Fongo Community Forums

This is my first crack at a guide. The last two weeks or so have been painful so if this helps anyone, good for you.

If you find any errors, let me know.

That's wicked marksy!

When we talked on the phone and you said that the DMZ only has one option, I was unsure what to say. But now I realize since you flashed your WRT54GS with the VoIP Optimized Firmware, it would of course only have on IP needed; for the VoIP device! *facepalm*...

I've compared it with my setup here and it is more or less the same for my Cisco IP Phone as well.

but fortunately (so far) I have not needed to enable it.

Which is good because if I port over my fax line (I know it is not supported) I'll need my other ATA set up.

For my own curiousness, what ATA are you planning on using for your fax line? - Not supported means no over the phone support, and limited (very) forum support from Steve and myself; it does work though.

For faxing it is safe to say putting the fax device in the DMZ would lessen any complications you may encounter.

The same as the one I have already, a Linksys PAP2.

We shall see.....I'll keep you posted.

marksy, how did you setup the username and password on ATA? are those also used FPL number and password? can you post a screen shot for line setup on ATA? thanks!