call history in OBi100

[maximebeauvais]

I have installed my OBi100.
I could received and call....no problem

I have requested my phone #transfer and it should be done next week

In the mean time, my OBi100 is only plug in my router. my actual phone line is not contected (I'm still using my old phone line)

However, I went in the OBi100 setting to change my password today (yes, it was still admin LOL)

in the status, under call history, there is over 180 call

look like this


**************
Call 3 10/04/2014 14:28:06 Remove

Terminal ID SP1 PHONE1
Peer Name 1002
Peer Number 1002
Direction Inbound Inbound
14:28:06 Ringing
14:29:06 End Call

************

What is this?

[Fongo Support]

I have installed my OBi100.
I could received and call....no problem

I have requested my phone #transfer and it should be done next week

In the mean time, my OBi100 is only plug in my router. my actual phone line is not contected (I'm still using my old phone line)

However, I went in the OBi100 setting to change my password today (yes, it was still admin LOL)

in the status, under call history, there is over 180 call

look like this


**************
Call 3 10/04/2014 14:28:06 Remove

Terminal ID SP1 PHONE1
Peer Name 1002
Peer Number 1002
Direction Inbound Inbound
14:28:06 Ringing
14:29:06 End Call

************

What is this?

Hi there,

Please see below:

http://forum.fongo.com/viewtopic.php?f=10&t=8326

and below:

http://obitalk.com/forum/index.php?topic=5467.0

If you added the IP of the OBI to DMZ in your router- please remove it asap.

Regards,

[maximebeauvais]

no, i have not touch the dmz setting, see picture of my router

do you have any other solution

[Fongo Support]

no, i have not touch the dmz setting, see picture of my router

do you have any other solution

Hi there,

In case you could not read the link from Obi forums and use Oleg method, please see below (Under Obi ATA security)

http://www.toao.net/500-mangos-guide-to ... obi202-ata

Regards,

[maximebeauvais]

i have done the method of inserting the ''AuthUserName'' in the X_InboundCallRoute

and so far, no fuky phone call in my history call

i have tested the line and I can do and received call no problem

thanks a lot for your time !!!

subquestion:
next week, my phone # will be transfered.
1) should I change the AuthUserName in the SIP tab with my transfered # or should I keep the one that FPL gave me?
2) I guess that I should do the same thing for the X_InboundCallRoute?

thanks again