DDWRT on a Linksys WRT54GS

[marksy]

This is my first crack at a guide. The last two weeks or so have been painful so if this helps anyone, good for you.

If you find any errors, let me know.

[FONGO_kris]

That's wicked marksy!

When we talked on the phone and you said that the DMZ only has one option, I was unsure what to say. But now I realize since you flashed your WRT54GS with the VoIP Optimized Firmware, it would of course only have on IP needed; for the VoIP device! *facepalm*...

I've compared it with my setup here and it is more or less the same for my Cisco IP Phone as well.

[marksy]

but fortunately (so far) I have not needed to enable it.

Which is good because if I port over my fax line (I know it is not supported) I'll need my other ATA set up.

[FONGO_kris]

For my own curiousness, what ATA are you planning on using for your fax line? - Not supported means no over the phone support, and limited (very) forum support from Steve and myself; it does work though.

For faxing it is safe to say putting the fax device in the DMZ would lessen any complications you may encounter.

[marksy]

The same as the one I have already, a Linksys PAP2.

We shall see.....I'll keep you posted.

[BruceW]

marksy, how did you setup the username and password on ATA? are those also used FPL number and password? can you post a screen shot for line setup on ATA? thanks!