Fongo Community Forums

Thanks Mango, I did end up at the password since it's hidden and I couldn't verify. Updated it according to FPL page and it now outgoing calls work! But the DoNotDisturbEnable is NOT checked off. Incoming still going to vmail. Wait...Now the unit is ringing with an incoming call!! And it seems to be...

Argh I'm back to square one. Inbound calls go straight to v-mail. Call log shows 2 entries for each call. First normal call clearing. Second disconnect reason = user busy. Outbound starts with 11 quick beeps followed by dial tone. I can enter the 10 digits but get the following messages. That passwo...

Situation unchanged. Incoming calls operational. Outgoing dial tone starts with a fast busy signal (about 6-8), followed by a regular dial tone. First digit stops dial tone, second digit is good. But the third digit triggers a very fast busy signal for several seconds. If you still have problems, ch...

Halfway there. Receiving calls ok. But dialing out gives me a fast busy tone when pressing for dial tone followed by the dial tone. Pressing first digit dial tone stops. But after the 3rd digit I get a regular busy tone. I tried a few different area codes. I'm on Rogers Cable. First I followed the o...

Thanks Mango, I will try and get back

Hello, All was well for over 14 months and yesterday incoming calls routed direct to voicemail and outgoing calls now get busy signal. Rebooted modem, router and OBI100. OBI dashboard shows SP1 FPl is registered. Test call to OBI is successful. FPL SIP settings Status = connected (with latest firmwa...