gogu392 wrote:Hi There,
I am not able to make calls to 311 number (city of Toronto).
The regular calls works.
I suspect that this is related with the DIal plan string set.
Can some one give a hint in this matter?
Thx,
gogu392 wrote:Is first time when I setup my Voip phone. I did spent 6 hours but is done and works.
Very importnat for a newbie is to read carelfully the senting and have the Firewall/Router and PAP device setup properly.
The ATA has a real time status, that helps. Any setings mater. All of them have to be setup carefully.
Now I have the ATA in DMZ, my goal is to have it behind firewall using QoS.
Is just a fine tune up. But with care I will have it done.
Good luck to all of you, read carfully the instructions, do not rush, take your time.
flob3d wrote:Solved !!!
But the config PAP support pdf is not completely!!
bYE
knowledgeeater wrote:How many users have working incoming calls with Pap2t using FPL account?
Thanks.
marginal wrote:knowledgeeater wrote:How many users have working incoming calls with Pap2t using FPL account?
Thanks.
I do.
knowledgeeater wrote:Would you please share your settings for it?
I have done Port Fwd. for 5060/5061 and 10000/20000. It's been down since Last December. I use Netgear router, any specific configuration did you do for router set up! Did you do any changes to Acanac's firewall?
Thanks.
marginal wrote:knowledgeeater wrote:Would you please share your settings for it?
I have done Port Fwd. for 5060/5061 and 10000/20000. It's been down since Last December. I use Netgear router, any specific configuration did you do for router set up! Did you do any changes to Acanac's firewall?
Thanks.
It is a little complicated for now (I have to go somewhere and do something in order to see the configuration), BUT, to me ports 10000/20000 are no good.
Also it works OK with my Speedtouch 780WL Gateway, but with my 2Wire Gateway I have a problem ...
knowledgeeater wrote:I have no incoming since dec. 2012. Outgoing is fine.
exhaust wrote:Can somebody help me on steps how to configure Linksys PAP2T-NA to block a list of phone numbers. They're a list of 1-800-xxx-xxxx telemarketing numbers. Thanks
Return to Device Configuration Sharing
Users browsing this forum: No registered users and 13 guests