diva wrote:Under “Ring and Call Waiting Tone Spec” category change Ring Frequency from 52 (recommended) to 26.
It worked for me.
Colorwolf wrote:The are with Fido
NPA=416
NXX=720
I have also tried some 905 phone number such but all it does is just go silent but when i check my log it says it was connected successfully. But I could not hear anything at all and the other side could not hear me either.
Thanks for your help.
mackey2001 wrote:Hello...here is my problem.....
I have a pap2 - with Vbuzzer's settings in Line 1
and on line 2 - I entered all the FPL settings.
Line 1 (vbuzzer) is working perfectly fine. but line 2 (fpl) is not working. Here are details :
====================================
Service Provider : Rogers
Dialtone : Yes, I do hear dialtone on my fpl line.
Call out : I can call out, but i dont hear the phone ringing, and the other party can not hear me if they answer the phone. According to the other part.. they do hear couple of beeps every 3-4 seconds... its like __ __ __ __ __ __
Call IN : No, whenever somebody try to call me - it gives them busy siignal. and ofcourse my FPL line never rings.
=====================================
What have I tried so far ?
I have hard reset my PAP2 a couple of times
I have just put FPL settings including rtp settings, user settings.
I have tried changing the codec settings to everything possible.
I have tried the port from 5060, 5061, 80, 6060.
=====================================
Even than.... my Vbuzzer still works fine, but FPL is not. Any help ??? Why are most of the settings here hitt and miss ?? is there any confirmed settings for PAP2 which is confirmed to work?
HELP HELP
Thanks
Mackey
hawkjordan wrote:Only way to get this around is turn off the router firewall (which I don't like to), or add all those ports in the range to those non-smart router port forwarding list...which is a pain...
hawkjordan wrote:With firewall turned on, *98 will take me to voice mailbox, but of course it brings up one way audio while in phone conversation.
sneek wrote:Is there any easy way for me to get both ports to work on the PAP2T. I want one phone number but I want it to ring to both ports, and allow either to pick up.
I have a great cordless phone set, but you really can't beat the reliability of a good wired handset. I would like to know if it is possible without me buying a combination wired/cordless phone.
Thanks in advance!
Return to Device Configuration Sharing
Users browsing this forum: No registered users and 21 guests