rrai12 wrote:I am having problem with the outbound calls and inbound calls. On Outbound call, I can call the number they can hear me out but I can't hear them. On inbound calls, No one can call me as it goes straight to voice mail so no incoming calls. I have no phone dial tone in my cordless phone. I have not changed any settings on Linksys PAP2T. It started happening after Bell increased my transferred me from FIBE6 to FIBE12 MB. I have virtually went through each setting on the Linksys PAP2T but nothing seems to work. Though I noticed when I call any number Phone1 light starts flashing. I am using DECT 6.0 cordless. I am on Bell 2 wire modem. Any clues would be helpful?
ancnfamily wrote:So I can make outbound calls but when i try to call my number i get 1 ring then fast busy. Any help would be appriciated.
Thanks
ancnfamily wrote:No luck. Sill same issue. Outgoing just fine, but can not call my number from any phone. How, when i dial my number i get fast busy. Druving me nuts.
Even tried this:
http://www.toao.net/25-linksys-ata-configuration
Thanks for help
dibsmft wrote:I seems like the ATA is not correctly getting your external address or that your port forwarding is not working or other devices on your network are grabbing the ports. I gather thay you have forwarded all of the required ports.
As a test, make sure that the ATA is the only device attached to your router in any way including wifi, power down the ATA and then the router. Wait about a minute and then restart the router and once it shows that it is connected restart the ATA. As soon as it shows that it is connected try calling the ATA from a PSTN phone (if you can) or cell phone (outside of your network!).
Any luck?
Return to Device Configuration Sharing
Users browsing this forum: No registered users and 21 guests