gogu392 wrote:Is first time when I setup my Voip phone. I did spent 6 hours but is done and works.
Very importnat for a newbie is to read carelfully the senting and have the Firewall/Router and PAP device setup properly.
The ATA has a real time status, that helps. Any setings mater. All of them have to be setup carefully.
Now I have the ATA in DMZ, my goal is to have it behind firewall using QoS.
Is just a fine tune up. But with care I will have it done.
Good luck to all of you, read carfully the instructions, do not rush, take your time.
Thanks, I don't know were is the problem.
How is NAT Support Parameters?
I found some configurations with NAT Support Parameters- Handle VIA received ,,yes,, Insert VIA received: ,,yes,, Handle VIA rport ,,yes,, Insert VIA rport: ,,yes,,
...
ok I have SINGTEL from Bell router/combo.
In Edit Firewall Settings i have:
,,Allow all applications (DMZplus mode) – Set the selected computer in DMZplus mode. All inbound traffic, except traffic which has been specifically assigned to another computer using the “Allow individual applications” feature, will automatically be directed to this computer. The DMZplus-enabled computer is less secure because all unassigned firewall ports are opened for that computer.,,
but in Edit Advanced Firewall Settings i have:
Outbound:
HTTP ,,YES,,
HTTPS ,,YES,,
FTP ,,YES,,
TELNET ,,YES,,
SMTP ,,YES,,
DNS,,YES,,
NETBIOS ,,NO,,
POP3 ,,YES,,
IMAP ,,YES,,
NNTP ,,YES,,
IRC,,YES,,
H323 ,,YES,,
ALL OTHER PROTOCOLS ,,YES,,
Attack Detection:
Check to detect the types of attacks below:
Excessive Session Detection ,,no,,
TCP/UDP Port Scan ,,yes,,
Invalid Source/Destination IP address ,,yes,,
Packet Flood (SYN/UDP/ICMP/Other) ,,yes,,
Invalid TCP Flag Attacks (NULL/XMAS/Other),,yes,,
Invalid ICMP Detection,,yes,,
Miscellaneous,,yes,,