Standard time

[ap236]

My phone isn't reflecting the correct time after the change last night. How do I fix this?

Thanks.

[Mango]

On the System tab of your ATA, set the following NTP servers:

1.pool.ntp.org
2.pool.ntp.org

On the Regional tab of your ATA, set the following Daylight Saving Time rule:

start=3/8/7/2:00;end=11/1/7/2:00;save=1

Save, reboot, wait a minute for NTP to sync, then check your ATA's info page. Current Time should now be correct. Let us know.

[radmila]

FPL. config file - Toronto number .
Cisco spa112
router tp-link tl-wr340g
telephone set at&t cl2909

In at&t cl2909, set up time on display manually to my correct EST time .
However incoming call triggers time in at&t cl2909 display back 3 hrs (Pacific zone).
at&t support told me 'my tel line provider' has to provide correct time which (time) is superimposed onto incoming call caller ID info.

How to fix incoming calls on my FPL NOT to change my EST time on at&t cl2909 display ?

[Mango]

Please set your time zone correctly as described on page 2 of the official guide: http://forum.fongo.com/viewtopic.php?f=15&t=16206

[radmila]

@Mango - thank you very much !

p.s.
on page 5 of that "Cisco SPA112 Configuration Guide for FreePhoneLine",
there is:

Step 8.
Go to ‘Voice’ tab, then click on ‘Line 2’:
Line Enable: no
????

Why Line 2 has to be DISABLED ?

What if I NEED on that "Line 2" another FPL number or e.g. SIP number from sipgate.de ?

[Mango]

Line 2 only needs to be disabled if it's unused. If you are using it for some other purpose, set Line Enable to Yes.

[radmila]

thank you again @Mango for your help.

[Mango]

You are very welcome.