[Resolved] SPA112s not registered at two different locations
Posted: 03/25/2023
Just wondering if there was any changes to freephoneline.ca settings recently, if not if can someone help me out.
I have 2 Cisco SPA112 at 2 different locations (2 different accounts) that no longer seems to work, pick up the phone I get no dial tone. If you call the numbers goes directly to VM.
I've been running the same config for years with out issue. I tried today to adjust my settings to SIP Server: voip4.freephoneline.ca:6060 Transport: UDP Port: 6060
to see if that would do anything. Same issue. (Previously it was voip.freephoneline.ca port 5060)
In my spa112 internet settings, they do show as Link connected
I do see that under Line 1 the registration state is showing as failed .. What would be causing that?
I'm using my cisco SPA112 at each location with Bell as the ISP and the Home Hub 4000.
Wondering if someone can point me in the right direction to get this working again.
I have 2 Cisco SPA112 at 2 different locations (2 different accounts) that no longer seems to work, pick up the phone I get no dial tone. If you call the numbers goes directly to VM.
I've been running the same config for years with out issue. I tried today to adjust my settings to SIP Server: voip4.freephoneline.ca:6060 Transport: UDP Port: 6060
to see if that would do anything. Same issue. (Previously it was voip.freephoneline.ca port 5060)
In my spa112 internet settings, they do show as Link connected
I do see that under Line 1 the registration state is showing as failed .. What would be causing that?
I'm using my cisco SPA112 at each location with Bell as the ISP and the Home Hub 4000.
Wondering if someone can point me in the right direction to get this working again.