Koolfreak wrote:I've tried first to configure my firt ATA Linksys PAP2 unit with Freephoneline technician, and I always had the "that password is not valid" message error.
After 30 minutes of configuration, the technician have concluded than my ATA unit was faulty.
I brought a brand new Sipura SPA-2000 last week. I configured all settings, and the same error message occured.
Need help to solve this trouble.
My router is a Linksys WRT150N and all the ports are open for the ATA.
Thanx.
admin wrote:Alright mjbad,
1. What you do is log into your FPL account using the email and password you used to register -- Go to freephoneline.ca and type that in.
2. Click on "FollowMe Settings" and where it gives you the option to, select "When Unavailable /FollowMe".
3. Enter (with no spaces or hyphens [-]) 1+AREACODE+0000000 and select "Save"
4. Select your desired number of rings, anywhere from 3 to 10 rings (3 rings = 12 seconds of ringing / 10 rings = 40 seconds of ringing).
5. Select save once more and you're done.
Your "FollowMe" number should look like this if your area code is 519... ---->15190000000<----
Thanks and you're all welcome!
------------------------------------------------
As for the volume of the handset, try turning your handset on Tone and turning the volume down. If it's cordless, it is the "Vol" button or other variations of "Volume", "Up / Down".
If it's corded, it's usually on the bottom or on the base under the handset.
Thanks again
Return to Tips & Tricks From Seasoned Users
Users browsing this forum: No registered users and 3 guests