southnam wrote:I have the SP2102 and just set up my ATA with the SIP settings given to me yesterday. It works fine for local calling but when I try to call a long distance number in one of the free cities in Canada the quality is horrible. It's a muffled, tinny, garbled sound and the other side says the same. Are there settings that I can play with or is this the quality that I may have to just end up living with for cross Canada calling?
Thanks
southnam wrote:Got in..
Codec was already set to no and the G711U was already chosen. Further help? Still not clear when I'm calling long distance.
mohnashaat wrote:i have linksys spa3102 it is very similar to spa2102 for line 1
i have some questions:
1- do i have to use the outbound proxy? (if yes how it is used or when?)
2- why setting (making and receiving calls without registration)
3- under Supplementary Service Subscription , why setting ''Cfwd All Serv'' and "Block CID Serv" to No.
4- on user 1 tab, how to set Cfwd no ans for example through gateways. (u wrote something on user 2 tab).
5- do we need provisioning ?
ma678 wrote:
1- Do I have to use the outbound proxy? (if yes how it is used or when?)
You do not, 'Outbound Proxy' is a service implemented by some SIP servers that forces all packets, including voice packets, to travel through that server in exchange for better supervision over charging etc...
2- Why setting (making and receiving calls without registration)
Not entirely sure what you mean here. Registering calls with registration would mean that before your call goes out it would ping our servers as to say "Am I allow to make this call?" and based on the response your call would or would not go through.
3- Under Supplementary Service Subscription , why setting ''Cfwd All Serv'' and "Block CID Serv" to No.
Since our server takes precedence over your device (Call forwarding and other services at least) there are some miscommunications that take place in a handful of devices that need to be rectified. To ensure this doesn't happen we would like you to disable all of these functions and manage them directly from your web interface.
4- On user 1 tab, how to set Cfwd no ans for example through gateways. (u wrote something on user 2 tab).
The answer is the same as #3 (Above).
5- Do we need provisioning ?
The long and short of it is no, not really. Provisioning is more or less only for firmware upgrades along with some other miscellaneous options that most users do not need.
southnam wrote:it's happening for all numbers that are not local. Can it be my set up. I have my internet line plugged into my dlink router and an ethernet from that into my 2102. Should it got into the 2102 first and then the router? Or does that not matter.
Help with my problem. Still can't call from Ottawa to Vancouver or any other non local number with a clear signal.
southnam wrote:it's happening for all numbers that are not local. Can it be my set up. I have my internet line plugged into my dlink router and an ethernet from that into my 2102. Should it got into the 2102 first and then the router? Or does that not matter.
Bloodsong wrote:Kris or Steve (or user in the know): Does the 2102 logging capabilities record which codec each call was made with? It may be worth turning on logging from your ATA if this information is made available and doing some long distance and local test calls to see how they're being handled.
Return to Device Configuration Sharing
Users browsing this forum: No registered users and 2 guests