streetcore wrote:how would outgoing calls work if there's only one phone? Is there a way to choose which number to use?
Yes.
**1 + outbound phone number sends call out through SP1 Service
**2 + outbound phone number sends call out through SP2 Service
**3 + outbound phone number sends call out through SP3 Service
**4 + outbound phone number sends call out through SP4 Service
You can change the outbound prefixes to whatever you want, but those are the defaults.
You can make any SP your PrimaryLine.
Physical Interfaces-->Phone Port-->PrimaryLine
You don't have to dial **x, where x is a number between 1 and 4, for your PrimaryLine.
The outbound prefix isn't required for PrimaryLine.
Incoming calls ring differently for each SP. They are defined first by the Ring Profile (A or B):
Voice Services --> SPx Service -->X_RingProfile (A or B is selected).
This corresponds with Ring Settings--Ring Profile (A or B)
And then the specific incoming ring for the SP is selected at Voice Services --> SPx Service --> X_DefaultRing.
So, you'll know which FPL number is being called based on the ring pattern.
Won't I have to make an outgoing call every 90 days with each number to keep each account active?
To ensure world credits aren't deducted, if you have any, you should make an outbound call every 60 days.
https://support.freephoneline.ca/hc/en- ... ld-Credits.
If you don't have World Credits, there's nothing to deduct; that link wouldn't apply to you.
Otherwise, no. FPL accounts aren't deleted due to inactivity for ported numbers or VoIP unlock keys.
https://support.freephoneline.ca/hc/en- ... t-deleted-"Accounts will not be deleted due to inactivity if they have one of the following:
1. Available World Credits
2. A number Ported to Fongo from another carrier.
3. You have purchased a Voip Unlock Key"
You would need to use a different email address to create a new FPL account, pay $99.95+tax for a new VoIP Unlock key, and pay an additional $25+tax to port in a number.
Only one FPL number is allowed per email address.
You would use the PDF guide located at the bottom of the first post in this thread to install FPL on an unused SP in your OBi200:
https://forum.fongo.com/viewtopic.php?f=15&t=18805.
If you've installed your original FPL VoIP unlock key on SP1, and if SP2 is unused, everywhere the guide mentions ITSP Profile A, you would use ITSP Profile B instead.
Additionally, If you've installed your original FPL VoIP unlock key on SP1, and if SP2 is unused, everywhere the guide mentions SP1 Service, you would use SP2 Service instead.
You would also create a new local DNS record under Parameter Name 2 on page 15 (instead of using the first entry). And I would not choose the exact same voipyourchoice.freephoneline.ca as you did for first entry.
When you reach page 28, for step 10C, don't use the exact same random number for X_UserAgentPort that you chose for your first VoIP Unlock key .