How to increase outcoming sounds?

[fooway]

When I call out, I can hear other people's sounds but other people told me that my sound was too small/light.

How to increase the outcoming sounds?

I use Linksys ata pap2t. Thanks a million!

[dibsmft]

From what you say the persons that you called were able to hear you it was just that the sound volume was too low? If you look at the configuration web page for the PAP2 (see manual) you should find adjustments for the incoming and outgoing audio levels. You should be able to increase the input level there but don't overdo it or you will get echo!

[fooway]

Many thanks for your reply. Yes, it was just that sound volume was too low. I looked at the configuration web page and manual but I don't know which one I should adjust. Does it change the "Silence Threshold" from "medium" to "low" or "high"? All "Audio Configuration" are as below. Thanks a lot!
--------------------------
Audio Configuration
Preferred Codec: Silence Supp Enable:
Use Pref Codec Only: Silence Threshold:
G729a Enable: Echo Canc Enable:
G723 Enable: Echo Canc Adapt Enable:
G726-16 Enable: Echo Supp Enable:
G726-24 Enable: FAX CED Detect Enable:
G726-32 Enable: FAX CNG Detect Enable:
G726-40 Enable: FAX Passthru Codec:
DTMF Process INFO: FAX Codec Symmetric:
DTMF Process AVT: FAX Passthru Method:
DTMF Tx Method: DTMF Tx Mode:
FAX Process NSE: Hook Flash Tx Method:
FAX Disable ECAN: Release Unused Codec:

[Jake]

Login in as admin, and click on the advanced view. Look on the 'regional' tab. Right at the bottom in the Misc' section there is FXS Port Input Gain and FXS Port Output Gain. Try changing those and see if that helps. The default should be -3 so go mad and try it as 5 You will probably find it far too high and it will probably produce echo, but it will give you another point to start from.

[dibsmft]

Jake is correct, at least for the SPA3201 but I am not sure about the PAP2. For my SPA3102 the settings that I arrived at (and the input volume is a little higher that I would prefer to hear myself but many of the b people that I call are somewhat hearing impaired) are

FXS Port Input Gain: 3 FXS Port Output Gain: -3

That works OK and does not give echo.

[fooway]

Many thanks for your guys' replies!

I will try it and hope it works.

Many thanks!