Linksys PAP2T settings for blocking caller ID?

[frangipani1900]

Does anybody know the settings to block outgoing caller ID (i.e. my phone number) on the Linksys PAP2T so that it does not display on the called party's phone?

[brentw]

I am wondering the same thing.
Also have a PAP2T.
I have tried disabling/deleting the *67 and *81 under the Regional tab with no luck.
And also changing "Block CID Serv" to "no" under the Line 1 tab, this just causes the "this call is not covered by your tariff plan" recorded message when I dial the *67 or *81

I would really like to know how to block my number from displaying for some calls.

[etrain]

don't think its possible with pap2t but i have a linksys RT31P2 and there is an option to block

[FONGO_kris]

Hmm, *67 works on Freephoneline software phone and my PAP2 here, what are you doing with the ATA? Change the internal settings?

[brentw]

Yes it works on the software phone after you check off the box to say Hide Caller Id in settings.
(shows the 416-642-0882 which is the generic number for caller ID blocked on Rogers and others)

For the ATA it only worked about 4 out of 10 times.
Nothing was changed between calls, they were one after another.
And I even put the ATA connected directly to my cable modem so there were no port forwarding issues.

Could you try using your PAP2 to call a non voip line (preferably a Rogers cell phone) and see if it works 10 times in a row from your PAP2?
The most I had it work was 3 times in a row and then on the 4th and most calls after that it showed my proper number even though *67 was still used.

I just tried again after 5 minutes and my number showed up even though I did *67.

If you could let me know if 10 in a row hides it every time for you when calling a non voip line that would be appreciated.

Thanks

Brent

[FONGO_kris]

I can try it yes.

*67 resets as soon as you hang up the phone as well, just an FYI.

[brentw]

Yep, I meant I tried 5 minutes later. I picked up the phone did *67 and the phone number and it still didn't work.
Just meant I tried it at a few different times to see if there was something weird at that time or something.

Pleast let me know how it goes doing 10 or so calls in a row.

Thanks

Brent