![Smile :)](./images/smilies/icon_e_smile.gif)
Equipment used are as follows :
Grandstream HT701 Rev.1.0.4.8
Router is a Cisco E900 with DD-WRT
I purchased an unlock key back in March 26. I continue to experience, my device not registering. The only way to resolve was to reboot the ATA or unplug and plug the power to the ATA. It would then register and then it would not register the day after.
1. I followed the instructions as per the forum : “Device Configuration Sharing / Grandstream HT-701” -> http://forum.fongo.com/viewtopic.php?f=15&t=5366.
2. I did as per the forum : http://forum.fongo.com/viewtopic.php?f= ... ter#p47216
I did as the post said and change the Nat Traversal to Keep Alive.
From post …
FXS Port:
Nat traversal(STUN) should be setup as "No, but send keep alive"- firmware 1.0.18-.1.0.43
For firmware version 1.0.43 and newer, please change it from "NO" to "Keep Alive"
Advanced settings:
STUN server is: this entry should be blank
Keep-alive Interval: should be 20.
3. I have also tried to swap the Primary SIP Server and Failover SIP Server (as per some other posts suggestion on this forum).
4. I have read and follow as best as I can the VoIP Unlock Key Credentials … http://support.freephoneline.ca/entries ... redentials
After doing all of this, I still get Not Registered.
Does anyone want to share their settings of their HT-701 (screenshot)? PLEASE. I want to see what I am doing wrong. Audio is great both ways. No issue there. It’s just the ATA won’t stay registered for no longer than 24 hours.