Buzzing in

[DENISM]

question .....i have ported my phone from bell to fongo and i live in a condominium where we have to buzz people in but unfortunately it doesn't work ..is there anything i can do to change that or is it a rule from fongo we cant use this future ?

Any help will be much appreciated

Regards

Dennis

[Jake]

A few people have mentioned this before, and I think it depends a lot on how your intercom system works.

If it dials your full number, rather than it just dialling 105 for your apartment and it going through a internal phone system, then it should work. If you get the calls on your number when someone is at your door, I would look in your ATA settings for the DTMF type and change it to something else. Usually inband fixes this sort of problem when the button pressing is not registered by an automated phone system for example.

[DENISM]

thank you for your reply ....
it dials just a 105 but after that you lost me ....i have no idea as to what is ATA or DTMF ...
Im not that good with that but if you can point out to me where to look for those settings i will give it a try ...
mind you i dont hear a call even if we dial the code on the door screen ...

But it worked before im sure of that i have this setup now over a month and i notice this door anomaly last thursday and ever since i cant open door ...

Thank you again for your time and any info you will provide

[46jimbo]

In my condo, I just plug a spare phone into the old phone jack (which is disconnected from Bell). I get a dial tone, but can't call out. However, it operates the door buzzer.

[DENISM]

ok thanks for your respond,i will look into it and see if that fixes the problem ...