Service drops out in the evening

[viper610]

today and yesterday i have had calls drop, and have not been able to dial out. just get 30 sec. silence and then a busy signal.

is anyone else experiencing this?

I haven't changed anything with my setup. I have another service setup on line 2 of my ATA and it seems to be fine.

thanks

[viper610]

also just checked my ATA settings and showed that the registration failed

then a couple minutes later it connected, but then i got a call and no one was there?

[curriegrad2004]

I've checked my logs on the PBX server, seems like there isn't an issue for me. Are the ports forwarded to your ATA working properly?

[mlaposta]

I've been getting this lately also, just started out of nowhere all of a sudden.

At first I thought it was the other person's phone, but when it happened a few other times on other days I started to get suspicious.
Then that same person told me they couldn't reach me on my phone when they tried to call me (they had to call my cell).

So I logged into my PAP2t, tried to dial out and saw that after about 10 seconds registration had failed.
When the ATA renewed after about a minute, it registered fine, and then I was able to call again.
I thought maybe just a temp glitch, but it keeps happening.

I haven't had much time to dig in and really test, but I seem to be getting the same issue as you ... silence and busy signal after a bit.
Also getting the exact same thing if I try to call my number from my cell.

Dunno if it's settings related, but funny how all these weird things have been happening ever since the upgrades.
Coincidence?

[viper610]

yes the ports are forwarded,

Running tommato, and forwarded port 5060 and 5061 to the spa2102. but i have been operating problem free for some time now with no changes to my network so this doesnt make sense i just checked now and registration is failed?

[viper610]

also have another line set up on line 2 with another provider that registers fine

[adamk]

I have similar problem this evening, cannot dial out. I didn't change any settings. Sometime ago reseting my box helped, but not this time.
On my PAP2NA I'm getting this message:
Registration State: Can't connect to login server

[viper610]

Miraculously it is now fine, I emailed tech support and the only thing I've changed was to forward port 10000-20000, but i did this after the problem seemed to resolve itself.