Not receiving calls

[k2366]

It seems I can make outgoing calls but there seems to be a problem with incoming calls.
All was fine until last Thursday when this began happening. I never touch the settings except to maybe enter a number to block which I did just prior to this.

[lustucru]

Is the DND option enabled? If so, dial *73 to disable it.

[k2366]

Is the DND option enabled? If so, dial *73 to disable it.

I take it that is on the "User 1" page of the Pap2 in the category "Supplementary Service Settings"?
Here are those settings.

CW Setting: Yes Block CID Setting: No
Block ANC Setting: Yes DND Setting: No
CID Setting: Yes CWCID Setting: Yes
Dist Ring Setting: Yes Secure Call Setting: Yes
Message Waiting: No DND Activated: No

I downloaded the config PDF for this ATA and based on that the NAT Mapping Enable is supposed to say yes & the NAT Keep Alive Enable is also supposed to be set at yes. Mine says NO.
I changed to Yes and as a result I had no dial tone. I have since reverted back to what I originally had, NO.

[Fongo Support]

Is the DND option enabled? If so, dial *73 to disable it.

I take it that is on the "User 1" page of the Pap2 in the category "Supplementary Service Settings"?
Here are those settings.

CW Setting: Yes Block CID Setting: No
Block ANC Setting: Yes DND Setting: No
CID Setting: Yes CWCID Setting: Yes
Dist Ring Setting: Yes Secure Call Setting: Yes
Message Waiting: No DND Activated: No

I downloaded the config PDF for this ATA and based on that the NAT Mapping Enable is supposed to say yes & the NAT Keep Alive Enable is also supposed to be set at yes. Mine says NO.
I changed to Yes and as a result I had no dial tone. I have since reverted back to what I originally had, NO.

Hi,

Please see Jake's reply below:

http://forum.fongo.com/viewtopic.php?f= ... er1#p44658

Regards,

[k2366]

Not sure what happened since I did nothing after my last post, but I am receiving calls once again.