how to correct daylight savings time

[bedihardeep]

hi there

my freephone doesn't set as per daylight savings time

how can i correct time as it shows 1 hour back after daylight savings time begins

I Contacted fongo support no reply ??????????

any help would be greatly appreciated

thanks

[Jake]

This is what I use for my daylight savings rule, and I think it works OK (On the Admin -> Advanced - Regional tab towards the bottom)

Code: Select all

start=3/8/7/2:00;end=11/1/7/2:00;save=1

The Time Zone is set at GMT -5 hours.

I also use these two servers as my NTP servers, but I know there are lots of others that can be used.

Code: Select all

time.windows.com
time.nist.gov

[bedihardeep]

This is what I use for my daylight savings rule, and I think it works OK (On the Admin -> Advanced - Regional tab towards the bottom)

Code: Select all

start=3/8/7/2:00;end=11/1/7/2:00;save=1

The Time Zone is set at GMT -5 hours.

I also use these two servers as my NTP servers, but I know there are lots of others that can be used.

Code: Select all

time.windows.com
time.nist.gov

i tried your settings and NTP servers still same

[Jake]

My phones only update the time when a call comes in.

There is a time in the ATA on the main page, does that say the correct time?

[bedihardeep]

My phones only update the time when a call comes in.

There is a time in the ATA on the main page, does that say the correct time?

yes i checked admin it says right time but i didn't check it before ,actually i was checking on my Panasonic cordless phone that display 1 hour back after daylight savings time comes in effect

and my cordless phone time setting is set to auto

[Jake]

Could it be your phone then? If the ATA is showing the right time, something else must be adjusting the time.

As I said, I have Vtech cordless phones, and the base station only updates it's time from the ATA when a call comes in. I guess it gets some kind of time signal from it that it reads. If the ATA is seeing the right time though, I would look at the phone next.

[bedihardeep]

Could it be your phone then? If the ATA is showing the right time, something else must be adjusting the time.

As I said, I have Vtech cordless phones, and the base station only updates it's time from the ATA when a call comes in. I guess it gets some kind of time signal from it that it reads. If the ATA is seeing the right time though, I would look at the phone next.

thanks for your help,you are best ..................it didn't update when I update settings even i try to call my voip but i just checked my cordless is showing correct time.