configuration for working SPA3102

[abhanwa]

I have a SPA 3102
firmware 5.1.10 GW

can some post a workin configuration screen shots if possible

issue I am having is

when I pick up handset I hear ring tone, cannot place a call if I dial a number call not received
when call my freephoneline nuber it goes straight to VM

config, I have a linksys 815 DIR router, freephone line is set to static and is in DMZ

any help

thanks

[selnes65]

Go to this site http://www.voipfan.net/ATAs/LinksysSPA_ ... eline.html

[mohnashaat]

for line 1, spa3102 is almost the same as spa2102

[abhanwa]

I also wanted to ask a question on network palcement,

I have been reading on various post and forums the best way to allow for this to work is to have the SPA3102 site just behind the ISP modem, and then have the router behind the SPA3102

the archtitecture I would like and I am having issue's getting this to work is


ISP --> Modem -- Router (d-link 825) --> Linksys spa3102 --> Telephone

I wanted to confirm someone has this type of setup maybe different Router etc.....

also still having issue with spa3102 not dialing out and incoming hear the call when I go to pick it does not answer

please help

[et750]

ISP --> Modem -- Router (d-link 825) --> Linksys spa3102 --> Telephone

I was able to put the spa3102 behind the router by disabling the spa3102 router function and using it as a Bridge/Switch.

Using command mode from the telephone, " **** ", "201#" here you can enter 1 to use as Bridge/Switch (0 to use as router)

I think I had to reboot my spa3102 (power off and on) to make it work